Weslo Cadence Cr12 Treadmill Manuel d'utilisateur télécharger pdf (Page 8)

6. Hold the Console (11) near the Console Base (87).

Touch the right Handrail (4) to discharge any static.

Locate the two wires in the Wire Harness (53) that have

L-shaped connectors on the ends. Press the connectors

onto the two tabs on the switch shown in inset drawing 6a.

Connect the other two wires in the Wire Harness (53) to

the back of the Console (87) in the locations shown by

the arrows in drawing 6. The connectors should slide

easily into the sockets and snap into place (see

drawings 6b and 6c). If the connectors do not slide easi-

ly and snap into place, turn the connectors and then

insert them. IF THE CONNECTORS ARE NOT INSERT-

ED PROPERLY, THE CONSOLE MAY BE DAMAGED

WHEN THE POWER IS TURNED ON.

Ties

Tabs

Connectors

Hinges

5. Insert the Battery Cover (12) up through the bottom of

the Console Base (87), with the hinges in the position

shown. The Battery Cover should pivot down, away from

the Console Base.

Remove the tape from the connectors.

Ties

4. Open part bag C. Set the Console Base (87) on the

Handrails (4). Thread four 3/4” Screws (5) into the

Handrails and the Console Base. After you have started

all four Screws, tighten the Screws until they are

snug; do not overtighten the Screws.

Insert the Wire Harness (53) through the two indicated

plastic ties on the Console Base (87) and then through

the hole in the bottom of the Console Base.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 21 22

Pas de commentaire

Weslo Cadence Cr12 Treadmill Manuel d'utilisateur Page 8