Weslo Cadence Cr12 Treadmill Manuel d'utilisateur télécharger pdf (Page 6)

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not

dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is

coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the

top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor-

mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild,

non-abrasive cleaner.

Assembly requires the included allen wrenches and your own phillips screwdriver ,

wire cutters , adjustable wrench , and needlenose pliers .

For help identifying the assembly hardware, refer to the PART IDENTIFICATION CHART below. Note: The

assembly hardware and other small parts are packaged in separate part bags. Do not open the part bags

until instructed to do so.

1. Make sure that the power cord is unplugged.

With the help of a second person, carefully tip the tread-

mill onto its left side as shown. Partially fold the Frame

(84) so the treadmill is more stable. Do not fully fold

the treadmill until it is completely assembled.

Open part bag A. Attach four Base Pads (33) to the

Base (38) with two 1 1/4” Tek Screws (9) and two 3/4”

Tek Screws (28). Attach a Wheel (42) to the right side of

the Base with a Wheel Bolt (41) and a Wheel Nut (22).

U-Nut (10)–4

Wheel Nut (22)–2

3/4” Tek Screw (28)–2

3/4” Screw (5)–10

Wheel Bolt (41)–2

3” Bolt (1)–8

5/16” Star Washer

(61)–8

1 1/4” Tek Screw (9)–2

1 2 3 4 5 6 7 8 9 10 11 ... 21 22

Pas de commentaire

Weslo Cadence Cr12 Treadmill Manuel d'utilisateur Page 6