Weslo Cadence 850 Treadmill Manuel du propriétaire Page 11

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 16
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 10
fewminutes.Repeatuntilthewalkingbeltisprop-
erlytightened.Ifthewalkingbeltstillslowswhen
walkedon,pleasecallourCustomerService
Department.
RearRoller
AdjustmentBolts
5. SYMPTOM: THE WALKING BELT IS OFF-
CENTER OR SLIPS WHEN WALKED ON
a. If the walking belt has shifted to the left, first
remove the SAFEKEY and UNPLUG THE
POWER CORD. Using the allen wrench, turn the
left rear roller adjustment bolt clockwise, and the
right bolt counterclockwise, 1/4 of a turn each. Be
careful not to overtighten the walking belt. Plug in
the power cord, insert the SAFEKEY and run the
treadmill for a few minutes. Repeat until the walk-
ing belt is centered.
b. If the walking belt has shifted to the right, first
remove the SAFEKEY and UNPLUG THE
POWER CORD. Using the allen wrench, turn the
left rear roller adjustment bolt counterclockwise,
and the right bolt clockwise, 1/4 of a turn each. Be
careful not to overtighten the walking belt. Plug in
the power cord, insert the SAFEKEY and run the
treadmill for a few minutes. Repeat until the walk-
ing belt is centered.
If the walking belt slips when walked on, first
remove the SAFEKEY and UNPLUG THE
POWER CORD. Using the allen wrench, turn both
rear roller adjustment bolts clockwise, 1/4 of a turn.
When the walking belt is correctly tightened, you
should be able to lift each side of the walking belt 3
to 4 inches off the walking platform. The center of
the walking belt should just touch the walking plat-
form. Be careful to keep the walking belt centered.
Plug in the power cord, insert the SAFEKEY and
run the treadmill for a few minutes. Repeat until the
walking belt is propedy tightened.
STORAGE
Unplug the power cord when the treadmill is not in use.
It is recommended that the batteries be removed from
the console and the treadmill be covered during
extended periods of storage.
Remove the bolt,
washer, and nut
from the lower
end of each
handrail.
Remove the bolt
and washer from
the upper end of
each handrail.
Slide the
handrails out of
the console hous-
ing.
Remove the bolt
and washer from
the lower end of
the upright. Lay
the upright on the
treadmill. Keep all
hardware in a
secure location.
Re move
11
Vue de la page 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire